AOC LM740 Specifications download pdf (Page 26)

26 Philips Fortimo HBMt Gen 3 System Design In Guide

Figure 28. Wire color coding on Xitanium Programmable LED

driver with Rset1

Figure 29. Color coding (one module connected to one

Rset1 driver)

Connecting one module to one driver

A standard cable is available for connecting the module to a driver. The color

coding of the wires in this cable corresponds to that in the Xitanium driver. If a

set-up with a single module and a single driver is used, the corresponding colors

need to simply be connected.

The unused Rset wires should be clipped short and wrapped with an insulating

material e.g. a berglass insulating sleeve.

Connecting two modules to one driver

It is possible to connect two HBMt modules in series to one Xitanium LED driver

by using two cables.

It is important to note that the driver can only communicate with one of

the modules.

This means that output current setting and Module Temperature Protection

read-out are only available on one of the two modules.

The unused Rset wires should be clipped short and wrapped with an insulating

material e.g. a berglass insulating sleeve.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 35 36

No comments

AOC LM740 Specifications Page 26