AOC 712Si ManualTABLE OF CONTENTSFOR YOUR SAFETY --------------------------------------------------1SAFETY PRECAUTIONS -------------------------------
9FRONT PANEL CONTROL Power Button:Press this button to turn the monitor ON or OFF. Power Indicator:Blue — Power On mode.Orange — Off mode. MENU / E
10HOW TO ADJUST A SETTING 1. Press the MENU-button to activate the OSD window.2. Press or to navigate through the functions. Once the desired
11ADJUSTING THE PICTURE The descriptions for function control LEDSMainMenuItemMain Menu IconSub MenuItemSub Menu IconDescriptionLuminance Contrast Co
12MainMenuItemMain Menu IconSub MenuItemSub Menu IconDescriptionAuto Config Yes N/A Auto Adjust the H/V Position, Focus and Clock of picture.No N/A Do
13PLUG AND PLAYPlug & Play DDC2B FeatureThis monitor is equipped with VESA DDC2B capabilities according to the VESA DDC STANDARD. It all
14TECHNICAL SUPPORT (FAQ)Problem & QuestionPossible SolutionPower LED is not on*Checkif the Power Switch is in the ON position*Power Cord should b
15ERROR MESSAGE & POSSIBLE SOLUTIONCABLE NOT CONNECTED :1. Check that the signal-cable is properly connected , If the connector is loose, t
16APPENDIXSPECIFICATIONSDriving system TFT Color LCDLCD Panel Size 43.2cm(17.0")Pixel pitch 0.264mm( H ) × 0.264mm( V )Video R,G,B Analog Interfa
17SwitchAuto Adjust Key Brightness Contrast Power Button MENUExternal Controls: FunctionsContrast Brightness Focus Clock H. Position V. Pos
18Preset Display ModesSTANDARDRESOLUTIONHORIZONTALFREQUENCYVERTICALFREQUENCYDos-mode 720 x 400 31.47kHz 70.0HzVGA640 × 480 31.47kHz 60.0Hz640 × 480
1Before operating the monitor, please read this manual thoroughly. This manual should be retained for future reference.FCC Class B Radio Freq
191 561011 1515 - Pin Color Display Signal CablePIN NO. DESCRIPTION PIN NO. DESCRIPTION1.Red 9.+5V2.Green10.Detect Cable3.Blue11.TXD4. RXD 12. DDC-Se
2PRECAUTIONS Do not use the monitor near water, e.g. near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet baseme
3SPECIAL NOTES ON LCD MONITORSThe following symptoms are normal with LCD monitor and do not indicate a problem.NOTES Due to the nature of the fluores
4INSTALLATION INSTRUCTIONS SWIVEL BASE Install Remove Figure 1 Installing and Removing the Swive
5your PC, depending on the type of power cord supplied with your LCD monitor.
6CONTROLS AND CONNECTORS VIDEO CABLEConnecting the Signal Cable: the LCD monitor comes with a built-in signalcable. Plug the signal cables 15-pin co
7ADJUSTING THE VIEWING ANGLE For optimal viewing it is recommended to look at the full face of the monitor, then adjust the monitor’s an
8OPERATING INSTRUCTIONSGENERAL INSTRUCTIONSPress the power button to turn the monitor on or off. The other control buttons are located on
Comments to this Manuals